Essential Tips - Playing a Gig

Whether you're a guitarist who's taking their first step into performing on stage or a grizzled veteran of the live circuit, we're here to help you out.

Essential Tips - Playing a Gig

The Soundcheck

Take the time to get to your band's sound right and then you can focus on the fun part

Do…

Learn the names of the sound engineers: treat them with respect and thank them at the end of the night, even if they do treat you like an amoeba.

Set your amplifiers to sensible volume levels onstage. Moderate levels allow the engineer to have more control over the overall front-of-house balance meaning that monitors don't need to be pushed to levels where they begin to feed back in order for singers to hear themselves.

Turn your amp on at least a few minutes before you start - it lets your valve amp warm up a bit.

Tune all your guitars (even your back- up) again as close to the start of your set as possible and make sure they're on hand and on stands. Things have a tendency to get knocked over in the heat of the moment.

Choose a song for soundcheck that will test the sound mix in the best way for all instruments in your band.

Listen carefully to the mix of instruments coming through the monitor speaker wedge - can you hear yourself and the rhythm section clearly to keep time?

Check as many of your sounds as you can: clean/crunch/distortion channels all need to be checked so they're at the right level. Ditto effects.

Talk to the other bands you're playing with on the night and find out what backline will be shared. While it's common for a headline band to let support acts share drum shells and stands, it's not for breakables like amps.

Be tuned-up and ready to take to the stage when the sound engineer needs you.

Don't…

Drink alcohol excessively before. It won't make you play any better!

Assume you'll be able to share gear and turn up with minimal kit. It should be easy to get contact numbers or email addresses for the other acts on the bill from the promoter or the venue, and it's common courtesy to ask first.

Crank your volume if your amp is being mic'd through the PA - you don't need a very loud onstage volume. Let the sound engineer get the levels. And you may not need your cab or combo front-on to the audience if it's being mic'd - angle it in a position best for you.

See soundcheck as a rehearsal or jam. One or two short songs should provide more than enough opportunity for the sound engineer to set up a decent mix. Taking liberties won't do you any favours with the other bands on the bill.

Leave your pedals running with the input plugged in for long periods of time ahead of the gig if you're using nine-volt batteries with your effects pedals - it drains the power unnecessarily.

Get bogged down with your onstage sound if you're playing outside. Put even more trust in the sound engineer's front of house mix - the nature of the external environment means your concern is playing in time, and the sound engineer's is making sure the audience get a good mix.

Play blazing lead lines when the sound engineer is tweaking the bass drum sound - he/she won't appreciate it.

Lose sight of the bigger picture - it's about attitude as well as the rig you're setting up. And remember that you get back what you put out. If you're confident, professional and polite, that's what you'll get back from the engineer and other bands.

The Gig

There's more to impressing the crowd than your blazing chops

Do…

Write a setlist for the show. Unless you're playing free jazz, you'll need a list of the songs you're playing and the order in which you're playing them.

Demand the audience's attention. The general rule of thumb is to open with a song that makes an impact.

Take a drink onstage with you - especially if you're a singer. You may be surprised to find your throat can get as dry as the Kalahari desert onstage, and you'll soon be begging for water.

Realise that things can go wrong - it's just part of gigging. Have contingency plans in your head in case the worst happens, including an instrumental piece the rest of you can play to fill time if one of the musicians has a problem they need to sort.

Look people in the eye while you're performing - engaging with your audience is more than just about sound.

Signal to the engineer if you need to communicate with the desk mid-gig: for example, if you can't hear your guitar clearly through the monitors or you're too loud.

Relax, listen to the sound engineer and remember that, ultimately, it's about the audience, not the band. Nobody cares that much about your tone except you, so stop stressing about it.

Don't…

Amplify your guitar when you're tuning up. You should tune quickly and silently between songs. Buy an electronic tuner with an easily visible display. The audience don't want to hear you tuning and it gives a sloppy, amateurish impression.

Forget to say the name of your band between songs. If you're a support act and don't have a banner, you can't assume anyone knows who the hell you are

Allow long silences between songs. While the guitarist or bassist tunes up, it gives the singer an ideal opportunity to crack a joke or, if they're not a natural raconteur, fill the silence by plugging the band's website or merchandise.

Mess with your amp settings during the gig based on the monitor speaker mix - it isn't a reflection of what the audience and engineer can hear out front.

Take forever to pack up your gear. Unless you're the headline act, the next band want to get onstage before the audience drifts away and loses interest. There will be plenty of time for excessive alcohol consumption and chatting up groupies once your equipment is off stage.

Be sheepish with the audience. Forget apologetic amateurism and smack them right between the eyes with your set!


Jordan Longlace
"I write what I like." - Steve Biko

To Top